John Bean® Scissor Alignment Lifts are easy to operate, provide increased accessibility to alignment adjustment areas and are easy to load. Space saving design allows for up to five scissor lifts to fit into the same operating space as four 4-post lifts.
Locked & Lighted models provide enhanced performance allowing the technician to perform critical tasks while minimizing alignment process operations, by illuminating both inspection and adjustment areas and by sequencing the locking of alignment plates.
Maintenance reduced rear slip plates use oversized, encapsulated bearings that roll upward to protect against environment debris
Four hydraulic cylinders in a cross-aligned arrangement provide secure lifting power and added safety
Approach ramps are equipped with end sliders to minimize noise and reduce floor damage
Adjustable maximum lift height suits locations with low ceilings
Safety systems include:
» Mechanical locking with pneumatic safety lock release from the control console
» Flow sensing valves within the hydraulic control circuit
» Redundant hydraulic safety system with cross aligned hydraulic circuits
On-board Filter/Regulator/Lubricator (FRL) provides clean and lubricated air to help reduce maintenance and protect pneumatic systems.
Professional pretreatment and powder coated painted surface.
Models equipped with locks and lights;
» have ease locking control activation from the lift console to reduce walking and effort from resetting alignment pins in plates
» include locking components made from corrosion resistant materials
» illuminate alignment adjustment and calibration areas
» front LEDs are mounted in the front turnplate base to easily accommodating varying vehicle wheel tracks
» rear LEDs are strategically positioned on the rear slip plates
All models have been tested and validated by an independent third party to the ANSI/ALI automotive lift standard, ALCTV-2011.
EELR593A - Standard Bay, Surface Mount, Locked & Lighted Model
EELR594A - Standard Bay, Flush Mount, Locked & Lighted Model
EELR591A - Standard Bay, Surface Mount
EELR592A - Standard Bay, Flush Mount
EELR589A - Short Bay, Surface Mount, Locked & Lighted Model
EELR590A - Short Bay, Flush Mount, Locked & Lighted Model
EELR587A - Short Bay, Surface Mount
EELR588A - Short Bay, Flush Mount
|Lifting times||80 s|
|Power supply||230V 1Ph 50/60Hz|
|Net weight||6387 lbs|
|Width Between Runways||38" inch|
|4 Wheel Alignment Wheelbase||88" - 155" inch|
|2 Wheel Alignment Wheelbase||180" inch|
|Air Supply Requirements||Psi|
|Overall Length||270" inch|
|Service Wheelbase||197" inch|
|Overall Width||92.5" inch|
|Runway Width||26" inch|