JLT 4500 S
The independent shop lift
PRODUCT DESCRIPTION
The JLT 4500 S has been designed to be in the position to lift cars from the smallest size up to medium size vans with standard roof
Flexible installation: the lift is available in 2 versions that can be installed in 2 different heights each at the time of the installation
Versymmetric® Technology: It combines the advantages of an asymmetric and a symmetric lift and improves the ergonomics when placing the arms to lift the car
Large swing range with 3-stage front and 3-stage rear arms
Controls are positioned in an ergonomic place on the primary column with clear indications of each push button
Power Pack is mounted high thus offering reduced noise performance
Shut-off bar: prevents cars to be damaged
Comfort lowering: the lift will automatically go up a little bit to release the carriage from the safety lock and will then automatically lower the vehicle
CE stop technology instead of mechanical foot guards
The 3 Stage arms allows always perfect access to the pick up points of every vehicle
A rubber protection on the carriage ensures that there are no damages to the car door
Optional remote control box to be mounted on the secondary column
FEATURES
3 Stage Arms
Front and rear 3 stage arms always allow a perfect access to the pick up points of the vehicle.
Carriage and arms
Very rugged design with integrated grease fitting and optimum door clearance when the car is placed on the lift. (Picture shows lift in wide installation)
Comfort lowering
Vehicle is lowered by simply pushing the lowering button. No need to activate the UP button to release the arms from the lock position.
Controls
Positioned in an ergonomic place on the primary column with clear indications of each push button.
Safety lock
Electric safety lock mechanism active during the complete lifting process is automatically released when lowering the lift thanks to the “Comfort Lowering” feature.
Versymmetric®
It combines the advantages of an asymmetric and a symmetric lift and improves the ergonomics when placing the arms to lift the car.
MEDIA
TECH SPECS
| Capacity | 4500 Kg |
| Capacity | lbs |
| Lifting times | 30 s |
| Lowering times | s |
| Lowering times (under nominal load) | 30 s |
| Lifting height | inch |
| Lifting height | 1965 mm |
| Maximum pad height from floor | mm |
| Maximum pad height from floor | inch |
| Drive-through width | inch |
| Drive-through width | 2.380 mm |
| Motor | 4 |
| Power supply | 400-415 VAC 3ph 50 Hz |
| Distance between columns | mm |
| Distance between columns | inch |
| Short arm extraction | 570 – 1.050 mm |
| Short arm extraction | inch |
| Long arm extraction | 950 – 1.650 mm |
| Long arm extraction | inch |
| Minimum ceiling height | 4.000 mm |
| Minimum ceiling height | inch |
| Minimum concrete thickness | mm |
| Minimum concrete thickness | inch |
Versions
The JLT 4500 T has been designed to be in the position to lift cars from the smallest size up to medium size vans with super high roof
